- Unplug or disconnect power.
- Remove the drum assembly from the machine.
- Remove the old seal from the drum assembly.
- Install new seal with stitched edge toward the front of drum (see
figure 1). Note: Make sure the white felt side of seal is on the drum
surface. ( see figure 1)
- Raise the seal to position it with the center fold against the drum
edge.
- Apply adhesive on drum under seal. Allow adhesive to set. Press down
seal to assure a good bond.
- Reinstall the drum. Reinstall the front panel.
- Place a small screwdriver or putty knife under the seal and on top
of the bulkhead.
- Turn the drum by hand one full turn, (counterclockwise making sure
the rear seal is riding on top of the ridge on the bulkhead and not
turned under. (See Figure 2).
- Reassemble dryer.
- Plug in dryer or reconnect power.
|
 |
